![]() ![]() In the image above, the grey line is the transmitted signal. This ability to "see" the wind is what enables the National Weather Service to detect the formation of tornados which, in turn, allows us to issue tornado warnings with more advanced notice. Information on the movement of objects either toward or away from the radar can be used to estimate the speed of the wind. The radar's computers measure the phase change of the reflected pulse of energy which then convert that change to a velocity of the object, either toward or from the radar. The same effect takes place in the atmosphere as a pulse of energy from NEXRAD strikes an object and is reflected back toward the radar. ![]() The faster the train moves, the greater the change in the whistle's pitch as it passes your location. Likewise, as the train moves away from you, the sound waves are stretched, lowering the pitch of the whistle. As the train approaches, the sound waves that make up the whistle are compressed making the pitch higher than if the train was stationary. You have most likely experienced the "Doppler effect" around trains.Īs a train passes your location, you may have noticed the pitch in the train's whistle changing from high to low. This Doppler effect was named after the Austrian physicist, Christian Doppler, who discovered it. The phase of the returning signal typically changes based upon the motion of the raindrops (or bugs, dust, etc.). The ability to detect the "shift in the phase" of the pulse of energy makes NEXRAD a Doppler radar. Learn about the different scanning modes of the Radar here The remaining 59 minutes and 53 seconds are spent listening for any returned signals. When the time of all the pulses each hour are totaled (the time the radar is actually transmitting), the radar is "on" for about 7 seconds each hour. NEXRAD spends the vast amount of time "listening" for returning signals it sent. This process of emitting a signal, listening for any returned signal, then emitting the next signal, takes place very fast, up to around 1300 times each second! Computers analyze the strength of the returned pulse, time it took to travel to the object and back, and phase, or doppler shift of the pulse. This reflected signal is then received by the radar during its listening period. Note: it's a small fraction of the emitted energy that is scattered directly back toward the radar. If the energy strikes an object (rain drop, snowflake, hail, bug, bird, etc), the energy is scattered in all directions (blue). The radar emits a burst of energy (green in the animated image). For a regional loop directly from the source, click here.NEXRAD (Next Generation Radar) obtains weather information (precipitation and wind) based upon returned energy. For more information about "Z" time, click here. Times (in the upper right corner) are in UTC or "Z". In the picture: Here is a quick regional radar loop from the last hour or so (assuming data is available) from the Aviation Weather Center. If that is the case, try the standard radar links or "Other Radar Resources" (Aviation Weather Center, MRMS, and NWS EDD) below. Note: At times, enhanced radar images may load and/or loop slowly (mainly based on internet traffic). In the picture: The new National Weather Service radar interface (officially released on December 17, 2020) will do a lot more than show where it is raining. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |